Discussion Forum: All Replies to Message 1466053

 Author: Dhobeck View Messages Posted By Dhobeck
 Posted: Apr 23, 2024 12:58
 Subject: Re: No dimensions on instruction for 41006
 Viewed: 22 times
 Topic: Catalog
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

Dhobeck (42)

Location:  USA, Montana
Member Since Contact Type Status
Oct 24, 2023 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: SirIceCreamMansBrixNFigs
In Catalog, KNI writes:
  In Catalog, crazylegoman writes:
  In Catalog Identification, KNI writes:
  Would you like to put dimensions on instruction 41006. When SH is calculated
when ordering, you will have to pay for an L letter (14 EUR) when there are no
dimensions on it. Otherwise, it can be sent as an S letter for EUR 4.20. The
dimensions are 20.5 x 18 x 0.3 (BrickOwl) I have tried to replace it with another
instruction with the same dimensions, but where the dimensions are in the overview,
and then it can be sent as an S letter.

You can add the dimensions for the item here:
https://www.bricklink.com/catalogReq.asp?itemType=B

in the "Change Item Dimensions To" line.

David

I can't l. Won't you do it. Kirsten

I have submitted a change request
 Author: Dhobeck View Messages Posted By Dhobeck
 Posted: Apr 23, 2024 15:29
 Subject: Re: No dimensions on instruction for 41006
 Viewed: 22 times
 Topic: Catalog
Cancel Message
Cancel
Reply to Message
Reply
BrickLink
ID Card

Dhobeck (42)

Location:  USA, Montana
Member Since Contact Type Status
Oct 24, 2023 Contact Member Seller
Buying Privileges - OKSelling Privileges - OK
Store: SirIceCreamMansBrixNFigs
In Catalog, Dhobeck writes:
  In Catalog, KNI writes:
  In Catalog, crazylegoman writes:
  In Catalog Identification, KNI writes:
  Would you like to put dimensions on instruction 41006. When SH is calculated
when ordering, you will have to pay for an L letter (14 EUR) when there are no
dimensions on it. Otherwise, it can be sent as an S letter for EUR 4.20. The
dimensions are 20.5 x 18 x 0.3 (BrickOwl) I have tried to replace it with another
instruction with the same dimensions, but where the dimensions are in the overview,
and then it can be sent as an S letter.

You can add the dimensions for the item here:
https://www.bricklink.com/catalogReq.asp?itemType=B

in the "Change Item Dimensions To" line.

David

I can't l. Won't you do it. Kirsten

I have submitted a change request

The change request has been approved