Author: | SylvainLS | Posted: | May 20, 2023 17:46 | Subject: | Re: Inventory Change Request for Set 10214-1 | Viewed: | 22 times | Topic: | Inventories | |
|
| In Inventories, bengreen28 writes:
| […]
Ok, I get they are listed in the alternate section to cover the holes of the
alternate 4x4 double inverted slope, but what do you use to bulk out the slope
when you put them together? I have got all the parts listed have nothing left
over and was short 8 2x4 plates, I'm using the double inverted slopes without
the holes they are the same dimensions.
Or are we meant to use the medium blue 1x2 plates that are put in the middle
of the block for no reason at all!!
|
Yes.
In the old version, they used the slope without holes and the 1x2 plates on the
ends, below the bricks with side studs.
When they added holes to the slopes (or did they remove the holes? ),
they had to fill them because they show very much.
So they added the white 2x4 plates and moved the 1x2 plates in this useless position
(add, never remove).
And they needed 2x4 because there’s 3 holes to cover in white and the 1x2 plates
are blue.
So, if you have the old version: don’t use the 2x4 plates there, use the 1x2
plates instead.
| Does anybody have a copy of the other version of instructions?
|
Nope, new one only here.
|
|
Message is in Reply To: Message Has 1 Reply: 8 Messages in this Thread: Msg 1 - bengreen28 (1936) 13 months ago May 20, 2023 to Inventories Msg 2 - Nubs_Select (3820) 13 months ago May 20, 2023 to Inventories Msg 3 - bengreen28 (1936) 13 months ago May 20, 2023 to Inventories Msg 4 - Nubs_Select (3820) 13 months ago May 20, 2023 to Inventories Msg 5 « - SylvainLS (46) 13 months ago May 20, 2023 to Inventories Msg 6 - bengreen28 (1936) 13 months ago May 20, 2023 to Inventories Msg 7 - SylvainLS (46) 13 months ago May 20, 2023 to Inventories Msg 8 - Turez (43) 13 months ago May 20, 2023 to Inventories
Entire thread on one page This message and all its replies on one page
|
|